idME PRO (Remote ID) – FCC Certificate

Press

The most advanced Remote Identification device

WI-FI and BLE technology

Our Remote ID module is based on the following technologies:

Wi-Fi (supported NAN and Beacon frames)
BT (supported BLE, and legacy frames)
GNSS (GPS, Glonass, BeiDou, QZSS, Galileo)

Using the BLE and WI-FI broadcast technology, our Remote ID (RID) device provides surveillance and drone operator identification capability based on any modern mobile device such as a smartphone or tablet.

Why Remote ID from Aerobits?

idME PRO (UAS Remote Identification) can be easily connected to Pixhawk controller via JST connector
Sniffer functionality – receive via Bluetooth and WI-FI signal form other RID devices
Increase of broadcast power to +20dBm Wi-Fi and +18dBm BLE
Automatic power adjustment according to the country of use
supports the newest MAVLink protocol, with Open Drone Id Messages
Extended configuration options allow choosing a transmission technology
Its small outline and low power consumption allow to be used in ultra-lightweight drones (20mA)
AT commands provide feasibility to configure broadcast messages, such as drone identification number, type of aircraft, etc. Additional authentication mechanisms are also available.

Notice:

FAA certification
FCC certification
EASA certification
In accordance with F3411 standard (ASTM)
CE certification pending

Basic technical information

Parameter	Description	Typ.	Unit
Frequency	Bluetooth	2.402 – 2.480	GHz
Max. output	Maximum output power BLE	+18	dBm
Frequency	Wi-Fi	2.4 – 2.485	GHz
Max. output	Maximum output power WI-FI	+20	dBm
ESD protection	All connectors		–
Interface baud	Configuraton or MAVLink	115200	bps
Main connector	SM06B-GHS-TB(LF)(SN)		–
Antenna connector	2x RF-IPX125-1G-AU		–
Temperature range	Operating temperature	-30 to +85	°C
Storage temperature	Optimal storage temperature	-5 to +40	°C
Dimension		32.0 x 16.7 x 7.5	mm
Weight (with antenna)		5	grams